Lifted Front Lower Control Arms (V2) - Fits 2024-2026 Subaru Crosstrek & Wilderness

The RalliTEK Lifted Front Lower Control Arms (V2) are built upon our V1 control arm design with additional reinforcement in key areas of the arm. Engineered and reinforced for extreme off-road and overlanding use, the V2 design retains the proven fitment and geometry of the original arm while incorporating targeted reinforcement where it matters most.

Compared to the V1 arms, the V2 design is 12% stiffer when loaded in the front-to-rear direction. Additional material is concentrated in the reinforced areas, keeping the weight increase to only about 0.54 lb per arm.

These control arms feature geometry correction for lifted vehicles, including ball joint angle correction. The added bend in the arm allows the ball joint to sit at a flatter angle than OE, helping accommodate the changed suspension geometry associated with lifting the vehicle.

The V2 design was developed using high-accuracy 3D measurements of the original geometry and evaluated using simulated impact loading. Under identical simulated loading conditions, the V2 arm matches the OEM component's yield capacity.

Features:

• Designed, tested, and proven on RalliTEK vehicles for extreme off-road and overland use.
• Reinforced construction with additional material in key load areas
• 12% stiffer than the V1 arm when loaded in the front-to-rear direction
• Only about 0.54 lb heavier per arm than the V1 design
• Geometry correction for lifted vehicles
• Ball joint angle correction
• Ground clearance gain
• OEM fit and finish for a bolt-in installation
• Rubber bushings for vibration dampening and OEM smooth ride quality, or RalliTEK Lifted Control Arm Bushings for additional articulation and longevity.
• Backed by our industry leading Lifetime Warranty
• 2 arms included. 1 kit is needed per vehicle

Pair with our RalliTEK Heavy Duty Adjustable Arms for a complete suspension arm setup for lifted off-road and overlanding vehicles.