RalliTEK

1/2" Front Lift Kit Spacers - Fits 2002-2007 Subaru WRX & STI

SKU: RTEK-830-414-000 ISBN: 1
$57.75
$57.75
Lifetime GuaranteeMade In U.S.A

These HDPE (High-density polyethylene) spacers are installed right over your factory strut hat. Great for adding more lift to a vehicle's original/aftermarket equipment or helping level out your fender gap.

Includes: 

  • 2 x 1/2" Spacers & hardware.

New strut mount hardware included! Class 12.9 bolts and class 8 to 10 nuts.

In comparison to aluminum spacers, our HDPE material is lightweight and not prone to additional NVH (Noise, Vibration, and Harshness), unlike typical aluminum spacers that transfer straight to the chassis. HDPE or high-density polyurethane has a compression yield strength of 20Mpa or 2900 pounds per square inch. 

Install Difficulty

Click Here To See Install Difficulty Guide For More Info

Est. Install Time -

3 Hours

This product is designed for off-road use only. Use of this product is at the buyer's own risk. - Click Here For Info

x2 RalliTEK Front Lift Spacers
x1 Hardware Kit

Compatible with:
Subaru WRX 2002
Subaru WRX 2003
Subaru WRX 2004
Subaru WRX 2005
Subaru WRX 2006
Subaru WRX 2007
Subaru WRX STI 2004
Subaru WRX STI 2005
Subaru WRX STI 2006
Subaru WRX STI 2007

Customer Reviews

Based on 4 reviews
50%
(2)
0%
(0)
50%
(2)
0%
(0)
0%
(0)
B
Brian
Should be made of aluminum

Install was relatively easy. Did not need to disassemble the strut, just used a ball joint tool to pop the old studs out. However, I've had to re-torque the top mounting nuts to 23 ft-lbs several times as the plastic material seems to compress and loosen the hardware to about 10 ft-lbs.

Hi there, thank you for your review and for choosing our 1/2' front lift kit spacers for your Subaru. We appreciate your feedback and are glad to hear that installation was relatively easy for you. We apologize for any inconvenience caused by the plastic material compressing and causing the hardware to loosen. We will definitely take this into consideration for future improvements. If you have any further concerns or questions, please don't hesitate to reach out to us. Thank you again for your support.

A
Aaron T.
Good quality

The spacers are good. Taking apart the strut assembly is a real pain to install them. I have not installed them because my strut mount was loose after re-assembly.

h
htimsdekim
These spacers do increase height by 1/2"

As advertised they increase the height 1/2". Installation is fairly straight forward and not too complicated. The only problem is being able to hold the bolt whilst tightening the nut. On one of the 3 bolts needed to mount the strut hat I needed to use a 6mm stubby hex to hold the bolt while tightening the nut and It was very difficult to make this happen. Customer support stated that the spacers had nuts recessed up in 'em, nah they did not

M
Michael N.
20k miles later and going strong

Put these in my 05 Forester with 255k miles. Very good springs!