Lifted Front Control Arm Bushings - Fits 18-26 Subaru Crosstrek & Wilderness

Introducing the Lifted Front Lower Control Arm Bushings for the 18-26 Subaru Crosstrek & Wilderness. When you lift your Subaru, the factory front lower control arm rear bushings are pushed past what they were designed to handle. causing premature wear, tearing, clunking, and sloppy handling.

With a 23° working angle, these front control arm bushings are designed to operate properly on lifted applications without binding or overstressing the joint. The added articulation increases the vehicle's strength and capability and reduces the common failures associated with OEM rubber bushings on lifted vehicles.

Constructed from forged chromoly and built around a true COM bearing design, this is not just a replacement — it’s a serious upgrade. The spherical bearing allows smooth, controlled articulation while maintaining precise steering feel and stability on and off-road.

To keep the elements out, we’ve added polyurethane protective boots to shield the bearing from dirt, mud, salt, and trail debris — extending service life whether you’re daily driving or deep in the backcountry.

Features

• 23° working angle vs. 17° OEM
• Designed for vehicles with up to 3 inches of lift
• Eliminates common OEM rear LCA bushing failure on lifted vehicles
• Forged chromoly COM bearing construction
  
• Poly boots protect from dirt and debris from causing noise
• Designed specifically for lifted Subaru applications
  
• Works in both cast aluminum and stamped steel OEM and RalliTEK brand arms
  
• Alignment recommended after installation

OEM Bushing Cross-Reference Part Numbers-20204FL020, 20204AJ000, 20204AG000, 20204AG040, 20204SG000, 20204FN100

If you’re running a lift and are tired of replacing factory bushings, these bushings are for you.

Note: Due to the COM bearing construction, these bushings will add additional NVH that can be felt in the floorboard compared to factory rubber bushings.